This unit uses the latest technology from Ublox to give the best possible positioning information and includes a larger built-in 25 x 25mm active GPS antenna with a UART TTL socket.
This is an updated GPS module that can be used with the Arduino Mega v2. This GPS module gives the best possible position information, allowing for better performance with your Ardupilot or other multirotor control platform. U BLOX NEO-6M NEO6MV2 GPS Module
The UBLOX NEO-6M GPS Module has a battery for power backup and an EEPROM for storing configuration settings. The antenna is connected to the module through a UFL cable, which allows for flexibility in mounting the GPS such that the antenna will always see the sky for best performance. This makes it powerful to use with cars and other mobile applications.
The Ublox GPS module has a serial TTL output; it has four pins: TX, RX, VCC, and GND. You can download the u-center software for configuring the GPS, changing the settings, and much more. It is really good software (see link below).
Note: The Ublox NEO-6M GPS Module is not compatible with the APM 2.8 Flight Controller.
Features of GPS Moudle:
- 5Hz position update rate
- Operating temperature range: -40 to 85 °C for TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for backup
- The cold start time is 38 s and the hot start time is 1 s.
- Supply voltage: 3.3 V
- configurable from 4800 baud to 115200 baud rates. (default 9600)
- Super Sense® Indoor GPS: -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- GPS antenna 18x18mm separate
Package Include
- 1 x Ublox NEO-6M GPS Board
- 1 x antenna detachable
Reviews
There are no reviews yet.